How to Install Living Bed Lift Kit Foldable
Jul 09, 2025
Leave a message
How to Install Living Bed Lift Kit Foldable
Confirm the installation position by ensuring there is approximately 2 inches of space between the rear of the lifter and the rear panel.The longest angle steel of the product should be aligned with the height of the sofa side plate.
Gently support the lift to reveal the installation hole, and mark the hole on the lift using a marking pen. (Note: Each hole should be 1.18 inches long to prevent any deviation in the hole position, and the hole position can be adjusted as needed).
Remove the lift and use an electric drill to punch the marked installation holes. Next, install the lift body and tighten the screws securely.
Position the lift behind the bed, provide support, and install the air rod. Note: One end of the thin rod is a telescopic air rod, which should be installed downward.
Push down on the lifter to close it, then measure the length and width from the bedside to the lifter. Determine the installation hole distance between the upper bed board and the lifter. Next, measure the length and width on the bed board to locate the corresponding installation hole position and mark it for punching.
To install the bed board, first use an electric drill to carefully drill holes in the desired positions. Next, place the bed board on the lifter and insert screws into each hole. Finally, use a screwdriver and pliers to securely tighten the screws and complete the installation. This simple process will have your bed board securely in place in no time!
