Common Problems And Solutions For Drawer Slides

1. The drawer does not pull or is very tight and not smooth, which indicates that the installation size gap is not enough, so that the furniture factory gap is loose by 1 to 2mm can be solved, check whether the size of the matching screw matches.

2. The derailment phenomenon of the derailment shows that the gap in the installation size is too large, and the furniture factory is required to reduce the installation size a little.

3. If the drawer appears uneven, first check whether the position of the mounting holes on both sides is consistent, and then check whether the drawer surface is angled at 90 degrees.

4. The drawer has two upper and lower drawers with the same installation size but cannot be interchanged, which indicates that the two drawer faces are inconsistent.

5. The phenomenon of pulling the surface to the edge indicates that the installation size on the right is not calculated according to the standard 12.5mm.

6. Draw the face to touch the panel or bottom plate, indicating that the hole is punched according to the standard size of the rail.